Measuring tapes are portable measurement tool utilized to measure the size of an object or the distance between items. The tape is marked along the tape edge in inches and fractional inches, usually in quarter-, eight-, and sixteenth-inch increments. A number of tape measures are marked in millimeters, centimeters, and meters on one edge. The most common tape measures are 12 feet, 25 feet, or 100 feet long. A 12-foot tape measure is handiest for people.
Measuring tapes are essential tool utilized in construction. The 25-foot length is known as builder’s tape and is also marked in feet and at 16-inch increments to make measuring the standard distance between wall studs a lot easier. The 100-foot tape, often of reinforced cloth, is useful for determining property boundaries and other exterior measurements. They might can be found in many styles and sizes, but all of them serve the same basic function: to measure objects. They are convenient and simple to use, specifically if you know the proper way to hold it. Keep the front of the tape at the point you wish to start the measurement from, and then extend it to the point where you want to stop. Read the first big number just before your stop point – it will tell you how many inches. Then, read the smaller lines of different sizes up to your stop point.
Put the measuring tape in front of you with its thumb lock on top and the tape nearest you. Using your left hand, put your thumb over the thumb lock, rest your palm over the case which holds the tape measure, and then press the tip of your index finger against the base of the case, just below its tang or end-clip. With your right hand, grab the tape. Hold the tang or end-clip with your right hand utilizing your index finger and thumb, and then pull it out by about one foot.
Hook the tang to the side of the item that you are measuring. With your left hand, pull the tape measure lengthwise to the other side of the object, and then push the thumb lock to prevent the tape from retracting. Now see the measurement. Record your measurement to be sure that you don’t forget it. Release the thumb lock to retract the tape.
It is a simple way of measuring through effective use of measuring tapes and your measurement completes. This is basically how you would go about utilizing a tape measure. In case you have never used on before, you’d probably have been a little confused by all these instructions, but when you get used to it, it basically becomes a very simple and easy thing to accomplish. Apply simple formula by holding front of your tape at certain point from where you start measurement and extend it until the particular point at which you would stop for measuring. The first large number appearing before the stop point is actually the number of inches being measured. There are a few smaller lines of different sizes at the stop point too which also must be understood.
A Measuring Tape must always come in handy since it is a diverse tool for the Construction and Industrial professional. Measuring Tapes are very versatile and allows one to measure around curves or corners.
